Tilt it up so you can see the bottom of the floorhead..
If you can’t see a visible blockage, squeeze along the hose to try and find it.Once you’ve located the blockage, try bending and squeezing the hose around this area.
Reattach the hose and turn on the vacuum to see if the blockage has been loosened enough to be sucked into the vacuum..If there’s no blockage in the hose, take apart the floor tool by removing the pin.Check for any blockages.. Why Has my Henry’s Power Cut Out During a Long Cleaning Session?.
Modern Henry vacuums have a. cut-out system to prevent the motor from overheating.If your vacuum has stopped working after being on for a long time, then this is likely to be the issue..
The vacuum should start functioning again once it’s cooled down.
If it doesn’t, you may need to contact Numatic for after-sales support.. Can Henry Vacuums be Used Without a Bag?.Step 3: Clean the Floorhead and Brush Roll.
The next part of your vacuum to clean is the floorhead.. Start by detaching the floorhead then removing the brush bar.Some Dyson cordless vacuums have a red latch for this, while others require you to use a coin to unlock the fastener.
Check the manual if you’re not sure.. You can use scissors to cut hair that’s become wrapped around the brush roll.This is an important step when deep cleaning a Dyson cordless, as the vacuums don’t have anti-hair wrap technology.. Next, use cold water to rinse the brush roll and a soft cloth to gently remove dirt.
(Editor: Elegant Freezers)